When IT burned out the gasket It also Took a nice bite Out of the Head From the HEAT I was lucky that it didn't do the same to the Block.
The first time this happened I thought it was a header gasket. So i made a header gasket sandwhich
you could say. Two Mr gasket gaskets with Copper RVT in between them and as it Burned away the gasket(it left the RTV) I also seen it had a mark down the edge of the block(carbon) which then i could tell it was the head gasket NOT the header gasket as i first thought. SO in the time it took me to figure it out It had Burned a .010 groove into the head(this is what it took to clean the head back up)
God doesn't like ugly.
