Thank you I sure would appriciate the dimentions of that s10,it may even work with the set up that I am doing. That could be helpful.
the answer to Kestebs question of how long is 6 1/2 inches from the base of the tranny or should I say the edge where the tranny meets up with the bell housing. to the tip of the shaft, I hope this answers your question.
Originally posted by gearhead:
Since I have not done this swap with a 9" clutch before, I would also be careful about the diameter of the center hub. I'm assuming it doesn't matter what the diameter is, but you never know. Make sure it won't interfere with the face of the flywheel or the inside diameter of the pressure plate ring.
I happen to have a junk '83 S10 2.8L sitting in the garage with a 14 spline 9" clutch on it. If you need dimensions, let me know.
