Hi I am putting a T-5 behind my 235 53 full pressured engine. Decided to go with a 3:08 rear,I think I will get better gas milage that way. Getting closer to completion of project. I need help with the cluch set up. I have a 14 spline 84 t-5. I have read past B-board messages that say to go with a 85 astro van clutch disk, is this the best way to go? If so what pressure plate do I use and flywheel? I need to figure this out so I can also have my engine balanced. If I'm correct you need the clutch assembly along with the crank rods and pistons to properly balance that 235. Is the astro van cluch disk the only option or are there others? Have heard that a 235 3/4 ton truck fly wheel takes an 11 inch disk if this is so where can they be found along with pressure plate? Thanks for any help you can offer, finding this B-board has been very helpful to my project.
------------------
